Scilox BL100 Manuel d'utilisateur télécharger pdf (Page 4)

BL100 User Manual

IMPORTANT NOTICE

– To ensure optimum performance of the fingerprint deadbolt, please

read the tips below before programming and installing.

1. Keep your fingers clean when operating the deadbolt, so that your fingerprints

can be recognized by the deadbolt’s fingerprint sensor.

2. When you first purchase and operate your new deadbolt, its factory default

setting allows you to unlock the deadbolt with ANY finger.

3. To ensure security, the manufacturer strongly suggests you immediately change

the default master passcode (98989) after initial installation

4. Prior to enrolling ordinary (non-Administrator) users, you must first enroll at least

one “Administrator User”. Administrator Users have the unique ability to

program the deadbolt and add/delete users. Conversely, “Ordinary Users” can

only open the door and have no access to the deadbolt’s programming menu.

5. Each user can register one fingerprint and one PIN (Personal Identification

Number).

6. When opening the door, if you hear the deadbolt alarm beep and see the

indicator light flashing, this indicates the deadbolt’s AA batteries soon need to be

changed with fresh AA batteries.

7. The deadbolt automatically shuts off after 10 seconds of inactivity. This setting

helps conserve battery life.

8. You can register up to 100 users on the deadbolt. 5 can be Administrator Users

(Code: 995-999), and the other 95 will be Ordinary Users (Code: 000-994).

9. To ensure accuracy of the deadbolt’s fingerprint sensor, be sure to keep the

sensor clean.

10. When cleaning the entire deadbolt, exercise caution by not using corrosive

cleaning agents which could damage the deadbolt’s glossy finish. Instead, the

manufacturer recommends periodically cleaning the deadbolt with furniture

polish wax (e.g. Pledge).

1 2 3 4 5 6 7 8 9 ... 30 31

Pas de commentaire

Scilox BL100 Manuel d'utilisateur Page 4